$129.99

Inventory on hand and available for shipping immediately

Clean regularly & change annually. Filters up to 150 GPD (gallons per day) of ultra-pure, low PPM water

Features:

  • 96% – 99% PPM Rejection
  • Membrane Type: Thin Film Composite
  • Maximum Operating Temperature: 113°F (45°C)
  • Maximum Operating Pressure: 100 PSI
  • Maximum Feed Flow Rate: 2 GPM
  • Maximum Feed Water Turbidity: 1 NTU
  • Maximum Feed Sit Density Index (SDI): 5 SDI
  • Chlorine Tolerance: <0 PPM
  • Dimensions (H x W x D): 12" x 2" x 2"
  • Weight: .5 lbs
  • Tariff: 8421990040

THERE ARE TWO INDICATIONS AS TO WHEN TO CHANGE YOUR MEMBRANES

  1. Test the RO and source/inlet water to see what percentage of the inlet water’s PPM the 150™ is filtering out (rejection %). You should see approximately 98% of the inlet PPM’s being removed when the membrane is new. If the rejection % falls under an acceptable level (typically 90%) it’s time to change the membrane
  2. When the flow rate of the product water slows down significantly. This can also happen if your pre-filters are clogged. If you change your pre-filters and the product water still flows slowly then it’s an indication you need a new membrane. When it doubt contact HydroLogic
SKU: 210000002905